Ambient Light Sensor - メーカー・企業と製品の一覧

Waterproof ambient light sensor, no power supply specification / M761APG-PHM100SS

Waterproof illuminance sensor, no power supply required (0 to 150,000 lux) / Model number M761APG-PHM100SS

There are various outputs, both analog and digital. This sensor is used to measure the brightness of light as perceived by the human eye, and it is mainly used in places where lighting is important, such as sports venues, offices, art galleries, museums, and hospitals. Accurate measurement of lux illumination under all environmental conditions.

企業：シロ産業
価格：Other

Other measuring instruments

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Tibbit No. #28 Light Sensor

Are you having trouble aggregating various sensor information? With "Tibbo-Pi," you can create industrial boards just by rearranging blocks!

■This is a block that can measure illuminance (surrounding brightness) in lux. *#00-3 is required for use; please combine it for operation. ■What is Tibbo-Pi? It is an amazing IoT device that modularizes over 60 types of I/O, sensors, connectors, etc., allowing you to develop a circuit board simply by combining these blocks. Moreover, since you can operate the block modules with a "Raspberry Pi," you can quickly develop IoT edge and gateway devices using the visual programming tool Node-RED. (Development is also possible in Python.)

企業：コー・ワークス仙台本社
価格：Less than 10,000 yen

Other Software

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Mounted ultraviolet radiation intensity sensor / Model number WPLP-UV-01

Installed ultraviolet radiation intensity sensor

It measures the irradiance (W/m²), defined as the ratio of the radiation flux (W) incident on a surface to the unit area (m²), in the UVA / UVB / UVC spectral range. With the adoption of a new photodiode, it is insensitive to ? and infrared light. The outdoor installation type is the MC8P-PHOT3S series. ■mV signal output It measures light and radiation in the spectral regions of VIS-NIR, UVA, UVB, and UVC as illuminance (lux) or irradiance (W/m²). It is also capable of measuring the number of photons per unit time and per unit area in the photosynthetically active radiation (PAR) wavelength range of 400 to 700 nm. The WPLP series does not require an external power supply.

企業：シロ産業
価格：Other

others

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Illuminance Sensor 'PCL-01B'

A light sensor suitable for applications in illuminance control and microclimate observation!

The "PCL-01B" is suitable for applications in illuminance control and microclimate observation, and it is an economical illuminance sensor. The sensing element features a combination of a silicon sensor and optical filters, providing high spectral sensitivity characteristics. The diffusion plate used for light capture accurately detects illuminance. Calibration is performed through comparative testing with a standard illuminance meter. 【Features】 ■ Excellent economy ■ Sensing element combines silicon sensor and optical filters ■ High spectral sensitivity characteristics ■ Diffusion plate accurately captures illuminance ■ Calibration is conducted through comparative testing with a standard illuminance meter *For more details, please refer to the PDF document or feel free to contact us.

企業：ロイヤル機器
価格：Other

Other measuring instruments

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Armin Illuminance Sensor ET9-ILL / ETB-ILL

The power needed for transmission is generated by solar cells! There's no need to worry about the timing, cost, or hassle of battery replacement.

This product is a battery-less wireless sensor that can be used in outdoor environments exposed to strong wind, rain, and sunlight. It operates using energy generated and stored by solar cells. It measures "illuminance" at regular intervals. Additionally, it measures the illuminance along with a "sensor-specific ID." Wireless transmission is possible each time. 【Features】 ■ Easy to install ■ Maintenance-free ■ Suitable for various usage scenarios ■ High waterproof and weather resistance ■ Wide communication area *For more details, please refer to the PDF document or feel free to contact us.

企業：アイテック
価格：Other

others

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

DALI-2 Lighting Control High Ceiling Motion and Illumination Sensor with Switch Input

No setup needed! Immediately usable DALI presence and illuminance sensor minimum configuration: 1) DALI BUS 2) Sensor + Switch 3) DALI-2 lighting fixture

We would like to introduce the "DALI-2 Human Detection and Illuminance Sensor with Switch Input" that we handle. This device is compatible with PIR motion sensors and features illuminance measurement and DALI-2 switch input. It can be used as a DALI-2 switch with the "single-pole" and "push button" sold in Japan. With the built-in application controller, you can set up operation linkage, multi-location detection, daylight utilization control, appropriate illuminance control, and lighting + human detection sensor control. 【Features】 ■ Detection range: Diameter of 24 meters at a ceiling height of 10 m ■ DALI consumption current: 2 mA ■ Diameter: 55 mm, installation hole: φ57 – 67 mm ■ DALI signal sending terminal block included ■ Can be used as a DALI-2 switch with separately sold "single-pole" and "push button" available in Japan ■ Green LED indicator for visually identifying the sensor's position ■ Settings can be configured using DALI-2 software or RAPIX software *For more details, please download the PDF or feel free to contact us.

企業：OZUNO TRADING JAPAN
価格：Other

System lighting and lighting control
Ceiling Lighting Fixtures
Spatial Design

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Installed radiation illuminance sensor / Model number WPLP-RAD-01

Fixed-type radiation intensity sensor

WPLP-RAD-01 measures the radiant intensity (W/m²), defined as the ratio of the radiant flux (W) incident on a surface to the unit area (m²), in the VIS-NIR spectral range (400–1050nm). These features are applicable to instruments suitable for measurements in the visible and near-infrared regions. The calibration of the probe uses the 577/579nm line of a Xe-Hg (xenon-mercury) lamp through a spectral interference filter. The outdoor installation type is the MC8P-PHOT3S series.

企業：シロ産業
価格：Other

others

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Installed illuminance sensor / Model number WPLP-PHOT-01

Illuminance (lux), defined as the ratio of luminous flux (lumens) incident on a surface to the unit area (m²), is measured.

The spectral response curve of the light measurement probe approximates the human eye's response curve known as the standard photopic curve V(λ). The difference between "WPLP-PHOT-01" and the standard photopic curve V(λ) in spectral response is calculated as error f'1. The calibration of the probe is conducted by comparing it with a photometer that has been calibrated by a primary metrology standard institution. The calibration procedure complies with CIE Document No. 69 (1987) "Method of Characterizing Illuminance Meters and Luminance Meters." Measurements are conducted by illuminating the probe with standard light A. The outdoor installation type is the MC8P-PHOT3S series.

企業：シロ産業
価格：Other

others

ブックマークに追加いたしました

ブックマーク一覧

ブックマークを削除いたしました

ブックマーク一覧

これ以上ブックマークできません

会員登録すると、ブックマークできる件数が増えて、ラベルをつけて整理することもできます

無料会員登録

Ambient Light Sensor - メーカー・企業と製品の一覧

Ambient Light Sensorの製品一覧